Rexroth Indramat DKC11.1-040-7-FW ECODRIVE 01 Servo Drive Controller Spare Part

DKC11.1-040-7-FW ECODRIVE 01 Servo Drive Controller

The Rexroth Indramat DKC11.1-040-7-FW is listed for spare-part enquiries relating to installed ECODRIVE 01 motion systems. This page identifies the complete drive designation so overseas maintenance teams, machine builders and industrial buyers can request the correct legacy component. The full code is the starting point for selection; the actual hardware revision, firmware and connected equipment must also be reviewed before a unit is offered.

For an existing machine, retaining the correct drive generation and command interface helps narrow the search and reduces avoidable ordering mistakes. A similar appearance or a matching current code does not establish interchangeability. Please use the complete DKC11.1-040-7-FW designation in your enquiry and send clear photographs of the original nameplate and front connections.

Product Identification and Technical Profile

Drive Family and Interface Matching

This listing belongs to ECODRIVE 01, design series DKC11.1. Its command-interface profile is Analog command; verify installed firmware. The interface must match the machine control architecture, wiring and software configuration. Verify the connector arrangement and the controller-side communication settings against the installed drive and the relevant project documentation. This is an ECODRIVE servo drive controller listing. Identification should follow the DKC nameplate and the corresponding drive documentation rather than a general PLC or control-section description.

The 040 and 7 fields are retained as type-code identifiers. They should not be used on their own to determine continuous output current, input voltage or motor power. Electrical ratings, cabinet conditions and permissible loading must be checked for the specific drive variant and installation.

Firmware, Parameters and Included Parts

The FW suffix identifies a firmware-dependent drive designation; it does not confirm which firmware release or software module is installed in an available unit. Before quotation, please specify the software reference currently used by the machine, any parameter backup and the required included items. Firmware modules, terminal plugs, covers, cables and documentation are included only when expressly listed in the offer.

Parameter transfer, drive commissioning and machine validation depend on the existing system. The buyer should have the original settings available and arrange installation by personnel familiar with the machine. A complete hardware match still requires verification of motor feedback, control signals and application parameters before returning the axis to service.

Information to Send with Your Enquiry

• Full model: DKC11.1-040-7-FW, with a readable nameplate photograph.
• Any material number shown on the original unit, hardware change index and serial label.
• Installed firmware identification and available parameter or project backup.
• Connected motor designation, feedback type and command-interface details.
• Required condition, quantity, included accessories and delivery destination.

These details allow the offered unit to be compared with the original equipment. If the supplied photographs or records are incomplete, the matching points will be listed for clarification. A material number will only be confirmed against appropriate documentation and the actual unit; a number from a different drive or motor will not be assigned to this product by assumption.

Condition, Price and Delivery

This is a legacy genuine spare-part sourcing listing. Availability, condition, completeness and any inspection information are confirmed for the actual unit before order acceptance. The displayed price is an indicative reference and is subject to final quotation for the confirmed unit, condition and delivery requirements. The minimum order quantity is 1 piece. Supply planning is up to 10 pieces per month, subject to sourcing and confirmation for this exact model.

For a unit confirmed in stock, dispatch is normally within one week after the agreed order requirements are met. Non-stock sourcing and lead time are negotiated separately. Packaging and transport arrangements are confirmed with the quotation. Please request photographs and the available condition information for the actual offered item before purchasing.

Request a Quote for DKC11.1-040-7-FW

Send the full type code, nameplate photographs and machine matching requirements to request a model-specific offer. The quotation will state the actual condition, included parts, confirmed price and agreed lead time. This listing does not establish manufacturer authorization, a fixed stock quantity, a warranty period or compatibility with an unreviewed installation.