TOKYO KEIKI TGMX2-3-PP-BH-G-50 Modular Pressure Reducing Valve

TOKYO KEIKI TOKIMEC TGMX2-3-PP-BH-G-50 Modular Pressure Reducing Valve

The TOKYO KEIKI TOKIMEC TGMX2-3-PP-BH-G-50 is an ISO 4401-03 modular pressure reducing valve that controls P-port pressure over an approximate adjustment range of 0.35 to 7 MPa.

Knob-Type Pressure Adjustment

The H suffix specifies a hand-knob pressure adjuster instead of the hex socket adjustment screw used on the BW model. This allows pressure adjustment without a separate hex key.

The standard adjuster is positioned on the B-port side. The valve uses the P line as its pilot source and includes a G1/8 pressure-gauge connection.

Technical Specifications

Operating Notes

• Release the knob set screw before changing the pressure adjustment.
• Secure the knob after the required secondary pressure has been obtained.
• Verify the regulated pressure with a gauge connected to the G1/8 port.
• The actual minimum setting pressure changes with hydraulic flow.
• Maximum flow is restricted at settings below 7 MPa.
• Tank-line back pressure increases the effective secondary pressure.

Selection and Ordering Notes

The BH and BW models share the same nominal pressure range, but use different adjusters. BH uses a hand knob, while BW uses a hex socket adjustment screw. Available installation space and the risk of unauthorized adjustment should be considered before choosing between them.

Confirm the complete PP-BH-G-50 code, knob condition, gauge-port plug and supplied seals before shipment. This model is a pressure reducing module and must not be listed as a check valve.